Home
NeoGuard
Jerseys
PunctureGuard
Accessories
Bearing Shield
Ceramic disc
Foam Grips
Brake Adj
Contact
Fitting Instructions

Patent PendingBack to NeoGuard
NeoGuard Main Page

1) Step 1 - Wrap the 2 velcro straps at the top of the NeoGuard™ over and then under the lower crown and pull back through the eyelets in the guard, only loosly attach them for now, this will help keep the guard out of the way whilst you attach the bottom straps.

2) Step 2 - Wrap the 3 velcro straps around the fork brace at the bottom starting with the middle one, always ensure you DO THEM UP NICE AND TIGHT.

3) Step 3 - Pull the top straps to stretch the Neoguard™, don't worry about stretching the eyelets as it's re-enforced eyelets are designed to stretch, once fitted it should be taught. The stretch reduces the gathering of the guard when the fork compresses. Finally, YOU MUST CUT OFF THE EXCESS VELCRO AFTER FITTING

Most riders leave the NeoGuard™ on permanently, although it's advisable to take off periodically to clean the fork. The NeoGuard™ is also designed so that you can use a jet wash on it, or spray bike cleaning chemincals on it without affecting it's durability.

You can also machine wash at 40 degree's to keep it looking pristine, although it's advisable to put it into a tablet bag as the velocro will grab onto your other cloths in the wash. When storing DO NOT FOLD AS IT WILL PERMENANTY CREASE, just roll up the Neoguard™ using the velcro straps to secure to itself as shown HERE..

Use the Sizing Guide to ensure you get the right size of NeoGuard. Print Instructions

(Will fit upside down forks but is slightly less effective. Always ensure there is enough tyre clearance)
RRP £12.99